Flowserve LRG 16-40 - Manual (Page 30)

30
Annex
– continued –
Establishing / changing node ID
In order to enable communication within the CAN bus system, each item of equipment (e.g. controller)
must have a unique node ID.
Terminal box open:
. Use a thin blade screwdriver to set the node ID via code switches
3 S – S7. Use the table as
reference.
. Replace terminal cover I and fasten cover screws H tightly.
3. Enter the adjusted node ID on the name plate.
4. If necessary (refer to installation instructions) change the node ID of the control equipment
LRR -40.
A node ID must not be used for more than one item of equipment in the CAN bus system.
The node ID 0 is not permissible.
Attention