Flowserve PMV D3 Digital Positioner - Manual (Page 19)

19
CALIBRATE
AutoCal AutoCal
Start tune
Actuator?
rotating
OK
TravelCal
Start cal
Perform
normal
LOSE PREV
VALUE?OK?
OK
OK
OK
OK
OK
CALIBRATE
TravelCal
LOSE PREV
VALUE?OK?
IN SERVICE
? Press OK
OK
OK
OK
OK
OK
OK
OK
OK
Direction?
direct
Direction?
reverse
Calibration in
progress
Calibration in
progress
Perform
Factory set
Perform
50%
25%
12%
L
M
S
Actuator?
linear
Actuator
single act
Actuator
single act
IN SERVICE
? Press OK
OK
Set point LO: Use the calibrator set to 4 mA
(or set another value on the display). Press OK.
Set point HI: Use a calibrator of 20 mA
(or set another value on the display). Press OK.
Pressure read out only possible on D3 with built
in pressure sensor.
Pressure LO: Use a supply of 2 bar (30 psi)
(or set another value on the display). Press OK.
Pressure HI: Use a supply of 7 bar (105 psi)
(or set another value on the display). Press OK.
Temp: Calibrate using a known temperature.
Aux input LO: Use the calibrator
and a power supply of 4 mA (or set another
value on the display). Press OK.
Aux input HI: Use a supply of 20 mA
(or set another value on the display). Press OK.
Pot: Potentiometer setting, if its position
relative to the gear segment has been changed.
See Section 8.
Full reset: Resets all the set values.
All these values ar
e set at the
factory befor
e deliver
y and
should not normally be changed.
CALIBRATE
Perform
CALIBRATE
ExpertCal