Flowserve APKD - Manual (Page 10)

APKD DOUBLE-CASE, DOUBLE-SUCTION USER INSTRUCTIONS 26999903 07-13
Page 10 of 55 flowserve.com
2.3.2 Lifting of bowl assembly only
Clamp the bowl assembly and center the lifting hook
for lifting and lowering the assembly into the
sump/suction barrel.
a) Lower the bowl assembly until the clamp
extensions rest on the foundation (use
appropriate supports).
b) Build the very first section of the column piping,
and lower the entire assembly to assemble the
next column section.
c) Continue to build until it is ready for discharge
head assembly.
d) Install the discharge head.
e) Assemble the motor.
Example: Lifting of bowl assembly
Figure 2.3
2.3.3 Lifting of suction barrel
Suction barrel (also referred as ‘Can’) is always
supplied separately and has to be installed into the
sump first. Install eyebolts on the flange of the
suction barrel and attach slings and straps to bring
the suction barrel to a vertical position. Move the
barrel for installation. Provide hand support to
prevent the suction barrel from swaying during
movement.
Example: Lifting of suction barrel
Figure 2.4
SUCTION BARREL (CAN)