ETA Centrino s doplňkovým příslušenstvím - Manual (Page 38)

Mounting and removal of small bowl (C), (Fig. 3)
Put the bowl into big bowl B so that locking lugs and moulded holes are in the right position
to each other. You can remove the bowl in the opposite direction. If the small bowl is not
inserted properly, lid D cannot be mounted on the big bowl.
Mounting and removal of lid (D), (Fig. 2, 3, 4, 7, 8)
Remove and mount the lid only when turning regulator A1 is in the OFF position.
Put the lid on bowl B so that the moulded hole on its edge fits exactly to the protruding
part on the edge of the bowl. Turn the lid clockwise till securing lug D1 snaps in safety
appliance A5 and till locking lug D2 snaps in the cut in the bowl handle. Pay special
attention to this operation. The lid is now secured in the proper position and drive unit
A can work. You can remove the lid in the opposite direction.
Filling hole (D3, F1), pushers (F, F2), (Fig. 2, 3, 4, 5, 7, 8)
You can add liquids or solid ingredients through the filling hole when drive unit A is on. Use
pushers F, F2 to move food in the filling hole.
Big pusher F activates safety lock A5 (you will hear a clicking sound) if you take it out
above ¾ of the level of filling hole D3. The drive unit will stop its operation. As soon as you
slide pusher F back, the safety lock is deactivated (you will hear a clicking sound) and the
drive unit can be started.
Small pusher F2 can be moved from filling hole F1 and it can be used to move food without
limitation of operation of drive unit A.
Note:
– If you want to add ingredients, do not use the big pusher to switch the appliance
on and off! Before removing the pusher from the filling hole, switch off the drive unit by
regulator A1.
– The maximum level for filling the hole is ¾ of its volume.
– If you use a small round hole F1 for putting in food (e.g. carrots, cucumbers), secure big
pusher F in lid D using lock stop D4 (Fig. 5). Thus, you will prevent possible rise of the
pusher in food processing.
Using accessories
Sickle-shapes knives (H, I), (Fig. 2, 3)
Big sickle-shaped knife H is intended for use in big bowl B.
Small sickle-shaped knife I is intended for use in small bowl C.
Assembly
Hold the knife at the upper plastic part and put its central hole to shaft B1, let it slide on the
shaft to the maximum position. Remove the knife in the opposite direction. Put the knife to
the bowl always before adding ingredients.
ATTENTION
- the small bowl in intended for use with small sickle-shaped knife I only; do not use it in
combination with graters,
- it is suitable for processing herbs, small amount of meat, onion, mayonnaise,
vegetables, children and diet meals,
- it is not suitable for processing liquid ingredients.
38
GB
/ 117