ESI NeON User Manual
Page 25
ESI
25
1-8/9-16 Button
NeON supports 16 control pots and 16 faders, even though only 8 of each are located on the front panel.
To switch banks, press the 1‐8/9‐16 button. When in 1‐8 mode, the LED in the button will be off, when in
9‐16 mode it will be on.
Data Entry Wheel Assignment
The Data Wheel can be assigned either using the Ctrl Assign procedure as described above or the
following:
1. Press the SHIFT + Data Entry Assign button. The LED will light.
2. Next, move the Data Wheel. The number of the controller will be displayed on the LED display.
3. Type in the MIDI controller number you wish to assign to the controller.
4. Press ENTER to complete the process.
5. Assigning a MIDI channel to the Data Wheel is the same as described above.
Program Store and Recall
NeON can save up to 16 configurations in internal memory. All controllers, MIDI channel, and other
settings are saved in non‐volatile memory. Patch 0 is default and is loaded at power‐up. This cannot be
changed by the user, but 1‐16 are fully programmable. To save a patch:
1. Press SHIFT + Save
2. Type in the location you with to save the current configuration in (1‐16)
3. Press ENTER
REMEMBER: Saving a patch permanently overwrites the previously stored configuration!!!
Recalling a patch is the same as Storing, except press SHIFT + RECALL.
Panic
If a MIDI system is “hung”, Panic button will send MIDI note‐off messages to every note on every
channel to restore order to the system.