ESI MI/ODI/O - Manual

1
MI/ODI/O add-on card
Owner’s manual
The MI/ODI/O has one Coaxial Input/Output, one Optical digital Input and
16 channels MIDI Input/Output.
The MI/ODI/O is designed to be used with the Waveterminal 192 series of
audio cards as an add-on. It’s easy to install and does not require any
additional power supply or drivers to install. No new IRQ set up involved.
The MI/ODI/O has one Coaxial Input/Output, one Optical digital Input and
16 channels MIDI Input/Output. The MI/ODI/O lets you get more from
your Waveterminal 192 series by adding the power of S/PDIF In and Out
and MIDI I/O.
MI/ODI/O driver already included in EWDM driver of Waveterminal 192
series. Therefore, by the installation of the driver of Waveterminal 192
series, you can use MI/ODI/O right away.
Just hook it up to your Waveterminal 192 card like a below picture and
you're ready to go!
1. To install the MI/ODI/O in your computer
1.Turn off the computer power and remove the cover.
2.You require one empty slot close to the Waveterminal 192 series.
3.Connect the MI/ODI/O connection cable to the Waveterminal 192
connector. The cable can be connected only one way.
4. Place the MI/ODI/O into the empty slot. Be careful not to touch other
cards to avoid any damage to the cards.