Remote controls, Loading batteries – Entone Amulet 300 (F1) User Manual
Page 23
Amulet High Definition IP Television Receiver User’s Guide
Copyright
2010 Entone, Inc. All rights reserved
21
Chapter
8
8
Remote Controls
LOADING BATTERIES
The remote control comes with AA-size batteries, which needs to be installed when you first receive your
system. When you replace old batteries, you should replace all of the batteries. Use batteries of the same
kind, for example alkaline or carbon zinc, and do not mix batteries of different kinds. Alkaline batteries last
longer than carbon zinc.
WARNING: Mixing old and new batteries or different types of batteries poses a fire hazard.
To load batteries to remote control:
1.
Press down on the battery cover‘s top latch and slide the cover off.
2. If you are changing out batteries, take out all of the old batteries.
3. Put
the new batteries in. Make sure you match the plus ( ―+‖ ) ends with the plus markings on the
battery case.
4. Slide the cover back into place.
Figure 8-1 Loading Batteries to Remote Control