Entone Amulet 300 (F1) - Manual (Page 16)

Amulet High Definition IP Television Receiver User’s Guide
Copyright  2010 Entone, Inc. All rights reserved . 14
CONNECTING THE TV USING COAXIAL CABLE
1. Use the coaxial cable that comes with Amulet to connect your TV‘s antenna input to the Amulet‘s
―COAX‖ connector.
2. Tune your TV to channel 3 or channel 4 to view the output (depending on selection of the CH3/CH4
switch at the rear panel).
NOTE:
 In the RF TV, factory set to use channel 3 or channel 4.
 To set RF TV to another channel ID, You can change the channel ID by toggling the CH3/CH4 switch
at the rear panel.
NOTE: The new channel ID will take effect immediately after the switch is toggled.
Figure 4-1 Connecting TV using Coaxial Cable
SETTING UP TV TO USE CATV
In order for the Amulet to feed video signal to TV using RF TV, your TV must be configured to receive signal
from CATV rather than from the antenna.
Most TVs use either a physical switch located on the rear of the TV or with on-screen programming to
configure to use CATV. Consult your TV owner‘s manual for instruction if required.