Drake EH24A/EH24A ASI - Manual (Page 19)

19 Operating Instructions (continued)
At this point, you can press ENTER to store all of the choices on page 14. Actually, you could store after setting
just one item or after two items, etc. But once you store a parameter(s), you must renter the program mode to
make any additional adjustments.
All of these settings can be set using a PC connected via the Ethernet port or through the Ethernet connection via the
DRAKE model SCTeci Control unit.
Having completed EH24A settings on page 14, you are now ready to setup each individual encoder.
19) Press ENTER for 3 seconds to enter program mode. Observe flashing display.
20) Use left or right ENCODER SELECT buttons to choose one of the installed encoders.
21) To set the encoder to typical default settings, press the up arrow, down arrow, and ENTER all at the same time.
Hold the three buttons in for several seconds and release.
22) If any of the encoder settings need changed from the default values, re-enter program mode and adjust each
encoder parameter as required.
23) Repeat from step 19 for each enabled encoder.
24) Press ENTER to store any unsaved changes.