DR Power TreeChopper - Manual (Page 21)

CONTACT US AT www.DRpower.com 21
Chapter 5: Troubleshooting
Most problems are easy to fix. Consult the Troubleshooting Table below for common problems and their solutions. If you
continue to experience problems, contact us at www.DRpower.com or call toll-free 1-800-DR-OWNER (376-9637) for support.
Troubleshooting Table
S YMPTOM P OSSIBLE C AUSE
Cutter Head Assembly is
off center  Attaching hardware from mount to frame is loose; tighten hardware.
 A pivot pin has pulled out of chassis and mount; reattach pin.
Trees becoming harder
to cut  Blades need sharpening; sharpen blades.
 Blades are damaged; replace blades as needed.
 Blades are out of adjustment; adjust blades.
 Circular Blades are not spinning freely; clean the top and underside of the Blades. Never
loosen hardware in an attempt to allow the blades to rotate.
Trees are not being cut
as close to the ground
 Cutter head assembly pivot needs adjustment; readjust bolts and jam nuts as required.
Before performing any maintenance procedure or inspection, stop the ATV and put it in park, lower the TreeChopper to the
ground, turn the ATV ignition to the “Off” position, remove the key and set the emergency brake.