DR Power 3-Point Hitch Rapid-Feed - Manual (Page 56)

DR ® Power Equipment
7 5 M E I G S R O A D , P . O . B O X 2 5 , V E R G E N N E S , V E R M O N T 0 5 4 9 1
1-800-DR-OWNER (376-9637) • www.DRpower.com ©2008 CHP, Inc. 248851
Daily Checklist for the 3-POINT HITCH DR RAPID FEED CHIPPER
To help maintain your 3-POINT HITCH DR RAPID FEED CHIPPER for optimum performance, we
recommend you follow this checklist each time you use your Chipper.
[ ] BELT: Check the Belt for wear, proper alignment and tension.
[ ] KNIFE and WEAR PLATE: Check the Knife and Wear Plate for tightness, nicks and wear.
[ ] GENERAL CONDITION: Check the general condition of the machine, e.g.; nuts, bolts, welds, etc.
[ ] HOPPER: Check that there is no material left in the hopper before starting the Chipper.
DISENGAGE PTO, SHUT DOWN THE TRACTOR ENGINE, REMOVE THE KEY, WAIT FOR ALL MOVING
PARTS TO COME TO A COMPLETE STOP, DISCONNECT THE PTO SHAFT FROM THE TRACTOR, THEN
WAIT 5 MINUTES BEFORE PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION ON THE
CHIPPER.