DR Power 3-Point Hitch Rapid-Feed - Manual (Page 16)

12 3-POINT HITCH DR ® RAPID-FEED™ CHIPPER
Unpacking the 3-POINT HITCH DR RAPID FEED
CHIPPER
NOTE: Unpacking the 3-POINT HITCH DR RAPID FEED
CHIPPER is a two-person job. We recommend you have an extra set
of hands available before you begin because the 3-POINT HITCH
DR RAPID FEED CHIPPER weighs 282 lbs.
Tools and Supplies Needed:
• Gloves
• Wire Cutters
• Pry Bar
• Hammer
• 1/2" Wrench
Parts supplied on Skid (Figure 2):
• 3-POINT HITCH DR RAPID FEED CHIPPER
• Hopper Assembly
• PTO Shaft Assembly(with PTO Manual)
• Extended Top-Discharge Chute (if ordered, see
Chapter 7 “Chipper Accessories”)
• Parts Box containing (Items below and Figure
3):
− Discharge Chute
− Safety & Operation Instructions Manual
− Hardware Package (Figure 4 and Table
below)
H ARDWARE P ACKAGE C ONTENTS (F IGURE 4)
I TEM # D ESCRIPTION Q TY
1 Bolt, 5/16-18 X 5-1/4" 2
2 Nylon Locknut, 5/16-18 8
3 5/16-18 x 1" Bolts 6
4 5/16" Flat Washer 12
5 Key, 1/4" X 1/4" X 1-1/4" 1
6 Knife
Gap Gauge 1
7 Set Screws, 3/8-16 X 3/8" 2
3
Figure 4
4
1
6
7
5
2
3-Point
Hitch
Chipper
Figure 2
PTO
Shaft
Hopper
Assembly
Parts
Box
Extended Top-Discharge
(optional Accessory)
Discharge
Chute
Safety & Operating
Instructions Manual
Hardware
Package
Figure 3
Safety
Glasses