DR Power Hydraulic 22-Ton User Manual

Page 19

18. Wrap the threads of the high-pressure hose fitting with

a hydraulic pipe tape and attach it to the hydraulic
pump (Figure 19). Securely tighten the high-pressure
hose fitting with a 10-inch crescent wrench.

19. Remove the hydraulic fluid filter from the plastic cover

and apply a thin coat of hydraulic fluid to the rubber
seal. Screw the filter onto the filter head (Figure 20),
located near the hydraulic tank. Once the filter seal
makes contact with the filter head, turn it an additional
3/4 turn. Hand-tighten only.

20. Bolt the fenders onto the fender brackets using two

5/16-18 x 3/4 inch long hex head bolts and locknuts
(Figure 21). The fenders are interchangeable (left or
right). Position the fender over the tire with equal
spacing in the front and back.

NOTE: Your DR 22-Ton Vertical/Horizontal Wood Splitter is

now completely assembled. Follow the “Start-Up
Procedure” in the following section, which adds oil to
the engine and hydraulic fluid to the hydraulic tank
before trying to start the engine.

Figure 20

Filter
Head

Hydraulic
Fluid
Filter

Figure 19

High-Pressure
Hose Fitting

Hydraulic
Pump

From Bottom
Valve Fitting

Figure 21

Fender

Bolts (Top
side) and
Locknuts