DR Power Hydraulic 22-Ton User Manual

Page 15

3. While supporting the hinge bracket (Figure 7), pull the

hairpin clip and remove the hinge pin to separate the
hinge bracket.

4. Pull out and twist the locking lever to lock it in the out

position.

NOTE: For the next step, use the third set of mounting holes

up from the Base Plate.

5. Make sure the notch is on top as you position the

hinge bracket onto the rail assembly (Figure 8). Install
two 1/2-13 x 1-1/2 inch long hex head bolts, lock
Washers, and nuts. Only hand tighten the nuts at this
time.

6. Position the base unit against the rail assembly

(Figure 9).

Figure 8

Hinge Bracket
(mount in the
third set of
holes up from
the Base Plate)

Bolts (far side),
Lock Washers
and Nuts

Rail
Assembly

Notch on
top

Base Plate

Figure 7

Hinge
Bracket

Hairpin
Clip

Hinge
Pin

Locking
Lever

Figure 9

Rail
Assembly

Base Unit

HAVE SOMEONE HOLD THE RAIL ASSEMBLY TO PREVENT
IT FROM FALLING DURING THIS PART OF THE ASSEMBLY.