DR Power Walk-Behind 6.5 (Pre-August 2010) - Manual (Page 30)

26 DR ® WALK-BEHIND LEAF & LAWN VACUUM
Installing the Optional Disposable Debris Bag Liner (P/N 21794, package of 12)
The Optional Disposable Debris Bag Liner extends the life of the Debris Bag and provides a convenient way
to empty the Debris Bag.
1. Unhook the two (2) Rubber Flexible Latches from the Latch Plates on the Top Shield Assembly. See
Figure 14b on page 25.
2. Slide the Debris Bag Frame all the way back in the Top Shield Assembly channels.
Tip: To hold the Frame, place the Frame Support into the slot provided in the side of the Top Shield
Assembly (Figure 15a ).
3. Unfold a Bag Liner, shape it, and insert the Liner into the Debris Bag (Figure 15b ).
4. Fold the Liner opening over the top of the Debris Bag frame and punch the liner through the Retaining
Pins on the outside of the front Bag Frame to hold the Liner in place (Figure 15b ).
5. Place the Debris Bag frame, with the Liner in place, in the channels and slide the frame all the way
forward and re-connect the two (2) Flexible Latches making sure that the Bag Presence Interlock Switch
is properly engaged (see
Figure 14c on page 25) and there is a good seal between the Bag Frame and
the Top Shield Assembly.
6. To empty a Bag Liner, follow steps 1 and 2 but remove the Bag Frame from the channels in the Top
Shield Assembly and allow the full bag to stand upright on the ground.
7. Unhook the Disposable Debris Bag from the pins on the Bag Frame, allowing the Bag Frame and the
outer Debris Bag to fall away leaving the Disposable Bag standing free.
8. Properly dispose the full Bag Liner and replace with a new Bag Liner in the reverse order, making sure
that the Bag Presence Interlock Switch is properly engaged (see Figure 14c on page 25) and there is a
good seal between the Bag Frame and the Top Shield Assembly.
Figure 15a
Figure 15b
Slot for Frame Support
Liner through
Frame Pin
Bag Frame Support
Top Shield Assembly
Retaining Pin
through Liner