DR Power Tow-Behind 13.74 Pro-XL (August 2010 - August 2014) - Manual (Page 10)

10 DR ® LEAF and LAWN VACUUM
Leaf System Safety and
Operating Instructions
Manual
Engine
Manual
Two Hand Knobs
Two 5/16" Flat Washers
Two 5/16" Lock Washers
Two 5/16" Push Nuts
Four 5/16-18 x 3/4" Bolts
Four 5/16" Flat Washers
Four 5/16" Lock Washers
Figure 6
Two 5/16-18 x 3/4" Bolts
Two 5/16" Locknuts
Two 5/16" Flat Washers
Eight 5/16-18 Locknuts
Eight 5/16" Flat Washers
Two Clevis Pins
Two Hitch Clips
5. Pull the Box Lips from the Pallet and set the Box Halves aside.
6. Cut the Wire Ties from the Corner Bars and the Impeller Outlet Duct and cut
the Banding from the Collector Panels with the Wire Cutters (Figure 4).
7. Remove the Product Package, Impeller Outlet Duct, 28" Hose with Cuff,
Boot Adapters, Corner Bars, and Accessory Box (if ordered) from the Pallet.
8. Remove the Styrofoam pieces on top of the Panel Assemblies and slide the
Panel Assemblies off the Pallet from the Lift Handle side.
NOTE: If you have the model with a Jack, crank the Jack just until the Frame is
lifted from the Pallet Blocking. If you have a model without the Jack, get the Trailer
Stand ready to support the Machine when removed from the Pallet.
9. Cut the Wire ties holding the Machine to the Pallet and roll the Machine
from the Pallet (Figure 5).
Compare the contents of the shipping carton and the Part Box with the Parts
Supplied list on this page. If there are any questions contact us at
www.DRpower.com or call 1-800-DR-OWNER (376-9637). Do not discard the
shipping materials until you are fully satisfied with your new DR
® Leaf and Lawn
Vacuum.
Parts supplied:

Left Side Collector Panel

Right Side Collector Panel
 Front Collector Panel
 Rear Collector Door Panel

Top Collector Cover

Impeller Outlet Duct

Frame Assembly
 Collector Base

7" and 8" Hose Adapter

Tow Beam Stand (Premier
models)
 Product Bag containing (Figure 6):
o Operating and Instructions Manual
o Engine Manual
o Two Clevis Pins
o Two Hitch Clips
o Small Bag containing:

Two Hand Knobs

Two 5/16" Flat Washers
 Two 5/16" Lock Washers
 Two 5/16" Push Nuts
o Small Bag containing:

Eight 5/16-18 Locknuts

Eight 5/16" Flat Washers
o Small Bag containing:

Four 5/16-18 x 3/4" Bolts

Four 5/16" Flat Washers

Four 5/16" Lock Washers
o Small Bag containing:

Two 5/16-18 x 3/4" Bolts

Two 5/16" Flat Washers

Two 5/16" Locknuts
Impeller
Outlet
Duct
Figure 4
Boot
Adapters
Corner
Bars
28" Hose
with Cuff
Product
Package
Accessory
Box
Collector
Panels
Lift
Handle
Pallet
Block
Figure 5
Jack (some
models)
Do Not Cut this Wire Tie
Wire Tie
Wire Tie