DR Power Tow Behind Premier 12.5hp B&S - Manual (Page 15)

CONTACT US AT www.DRpower.com 15
Figure 16
Cable
Clamp Bolt
Return
Spring
“Z”-Bend
Cable Clamp
Pivot Arm
Pull
Figure 13
Cable Clamp
Bolt
“Z”-Bend
Cable Clamp
Pivot Arm Pull
3. Insert the “Z”-Bend of the Cable end into the top hole in the Throttle Pivot
Arm on the side of the Engine (Figure 13).
4. Using a 5/16" Wrench, loosen the Throttle Cable Clamp Bolt, and slip the
Cable Sheath behind the Clamp.
5. Pull the Cable as far as possible towards the front of the machine. This will
move the Pivot Arm into the Choke position.
6. Tighten the Cable Clamp Bolt while holding the Cable in the Choke position.
Throttle Cable – Pro-XL 20 HP Kohler
Tools Needed:

T25 Torx Bit
1. Route the Throttle Control Cable from the Tow Bar next to the Carbon
Canister and then to the Throttle Linkage on the left hand side of the Engine
(Figure 14).
2. Move the Throttle Control to the Choke position on the Remote Control
Panel (Figure 15).
3. Insert the “Z”-Bend of the Cable end into the bottom hole in the Throttle
Pivot Arm on the front of the Engine (Figure 16).
4. Using a T25 Torx Bit, loosen the Throttle Cable Clamp Bolt, and slip the
Cable Sheath behind the Clamp.
5. Pull the Cable as far as possible towards the front of the machine. This will
move the Pivot Arm into the Choke position.
6. Tighten the Cable Clamp Bolt while holding the Cable in the Choke position.
7. Pull the excess Cable away from the Muffler area and secure to the Carbon
Canister with a Cable Tie (Figure 14).
Cable Tie
Figure 14
Throttle
Cable
Muffler
Carbon
Canister
Remote
Control
Panel
Figure 15
Choke
Throttle Control
Lever