DR Power Tow Behind Premier 12.5hp B&S - Manual (Page 14)

14 TOW BEHIND DR ® FIELD and BRUSH MOWER
Figure 10
Cable Clamp
Bolt
“Z”-Bend
Cable Clamp Throttle
Linkage
Pull
Throttle Cable – Premier 12.5 HP Briggs and Stratton
Tools Needed:

T25 Torx Bit
1. Route the Throttle Control Cable from the Tow Bar up to the Throttle Linkage
on the right hand side of the Engine (Figure 8).
2. Move the Throttle Control to the Choke position on the Remote Control
Panel (Figure 9).
3. Insert the “Z”-Bend of the Cable end into the hole in the Throttle Linkage on
the side of the Engine (Figure 10).
4. Using a T25 Torx Bit, loosen the Throttle Cable Clamp Bolt, and slip the
Cable Sheath behind the Clamp.
5. Pull the Cable as far as possible towards the front of the machine. This will
move the Linkage into the Choke position.
6. Tighten the Cable Clamp Bolt while holding the Cable in the Choke position.
Throttle Cable – Pro 15 HP Kohler
Tools Needed:

5/16" Wrench
1. Route the Throttle Control Cable from the Tow Bar up to the Throttle Linkage
on the right hand side of the Engine (Figure 11).
2. Move the Throttle Control to the Choke position on the Remote Control
Panel (Figure 12).
Figure 8
Throttle
Cable
Remote
Control
Panel
Figure 9
Choke
Throttle Control
Lever
Remote
Control
Panel
Figure 12
Choke
Throttle Control
Lever
Throttle
Cable
Figure 11