DNF Controls ST200-S-TBL - Manual (Page 7)

7 ST200-S
d. RECORD MODE SELECTION
Four (4) Record modes are available: Crash Record (Full Record), Assemble Record,
Insert Record and Record Lockout.
The ST200 offers 2 methods of selecting the desired RECORD MODE, Rear Panel DIP
switches or Front Panel SETUP.
1)
METHOD #1 - Rear Panel DIP Switches
This method allows selection of the RECORD MODE using the Rear Panel DIP
Switches. Set the DIP Switches per the following Record Selector Switches
table. Any attempts to change the RECORD MODE from the Front Panel
SETUP function will be inhibited.
2)
METHOD #2 - Front Panel SETUP
Set the Rear Panel DIP Switches per the Record Selector Switches Table to
enable the Front Panel Record SETUP function.
Press the [SETUP] key on the front panel. The current record mode will be
displayed.
Press the [RECORD] key to select Record Lockout, Assemble, Crash, or
Insert Record modes.
For Insert selection, Press Number Key- "0" for Video.
[1] for Audio 1.
[2] for Audio 2.
[3] for Audio 3.
[4] for Audio 4.
Press [ESCAPE] to save the currently displayed Record mode and exit the
SETUP function.
Upon exiting SETUP, the VTR will be configured for the selected Record
Mode.
e. RECORD SELECTOR SWITCHES
Mode
S1 S2 S3 S4 S5 S6
Record Lockout OFF OFF OFF OFF OFF OFF
Assemble Record ON OFF OFF OFF OFF OFF
Crash Record OFF ON OFF OFF OFF OFF
Insert Record ON VID AUD1 AUD2 AUD3 AUD4
ActiveON
Front
Panel SETUP OFF OFF OFF OFF OFF ON
NOTE: AUD3 & AUD4 should be ON ONLY for VTRs that support 4 channels of audio
(i.e. D1, D2 and D3 type VTRs)
f. TIME CODE DISPLAY
Display timecode or CTL Tape Timer per the mode selector switch on the front panel of
the VTR. The Time Mode can be selected manually by pressing the [SHIFT] + [JOG]
keys, each press will step to the next Time Mode: CTL Tape Time, Timecode, VITC.