beautypg.com

Installation, 5 st200-s – DNF Controls ST200-S-TBL User Manual

Page 5

background image

5 ST200-S

4. INSTALLATION


a.

Plug one end of a 9-conductor, RS422 serial cable in to the 9-pin connector on the rear of
the ST200. Plug the other end of the cable into the 9-pin remote connector on the VTR.


b.

Plug the 9-pin female connector, of the Universal Power Supply, into the POWER
connector on the rear of the ST200.

Plug the free end of the Universal Power Supply into a wall outlet, 90 VAC to 240 VAC,
(+10%).


c.

Select REMOTE mode on the VTRs front panel.


d.

Set the RECORD SELECTOR SWITCHES, located on the rear panel of the ST200, for
the desired record mode per the "RECORD SELECTOR CHART" below.


NOTE- for AMPEX 1-inch and D2 VTRs, set VTR ID to 0001.

Installation is complete.

See also other documents in the category DNF Controls Equipment: