Digi-Star EZ 3200/EZ 3200V/EZ 3200V RC - Manual (Page 9)

Digi-Star Model EZ3200/EZ3200V/EZ3200V RC 4. Matching EZ scale to another scale
6
! copyright - 10/24/2001
CONNECTING EZ INDICATOR TO
OTHER LOAD CELLS You will need the number and type of load cells
used in the new scale system. You will also need
the current "SETUP" and "CAL" as described
above. Once you have written down this
information, contact your nearest Scale Service
Center for new "SETUP" and "CAL" numbers.
Follow the instructions “To Change the Setup /
Calibration Numbers” shown below.
Press and hold the key, then press the
key, to enter Short Form Setup & Calibration.
CHANGE SETUP AND
CALIBRATION VALUES The first message displayed is SETUP.
Next, the actual SETUP number is displayed.
! Press the key for additional help
information during Setup and Calibration.
If the correct SETUP number is displayed, press
the
key to advance to the CAL number.
1. Press the key to cause the “flashing” digit
to count upward.
2. Press the key to select which digit is
flashing.
When the correct SETUP number is displayed,
press the
key to advance to the CAL number.
This displays the CAL message,
followed by the CAL number.
! The CAL number is not a weight. It is a
reference value the indicator uses to determine the
weight. This number directly affects the accuracy
of the scale system.
Change the CAL number using the same method
described in Steps 1& 2. When the display shows
the correct number, press the
key.
This causes the number to be stored permanently
in the indicator and returns the indicator to the
weighing mode.
SETUP
1
2
and
127060
127062
2
1
CAL