Digi-Star EZ 3200/EZ 3200V/EZ 3200V RC - Manual (Page 15)

Digi-Star Model EZ3200/EZ3200V/EZ3200V RC 6. System operation
12
! copyright - 10/24/2001
TO ENTER A PRESET A Preset is a weight amount that can be set in
the scale.
1. Use the numeric keypad to enter the desired
preset weight value.
2. Press . The indicator will round the preset
amount to the nearest display count size.
3. Add or remove weight. The scale alternates
between flashing the word PRESET and the preset
amount, until 5 percent of the preset weight is
either loaded or unloaded.
4. While weight is being added or removed, press
to display weight data in Gross Mode or,
press to display weight data in Load/
Unload Mode.
5. To display weight added since the preset was
entered, press two times if in Load/Unload
Mode or one time if in Gross Mode.
Once the preset has been entered, the display shows the weight data in one of three different
Display Modes:
1. Gross Mode
As ingredients are loaded, the weight display counts upward toward the preset value. As
ingredients are unloaded the weight display counts down to the preset value.
2. Load/Unload Mode
Display the amount remaining to be loaded or unloaded. As ingredients are loaded or
unloaded, the display counts down from the entered preset weight until it reaches zero.
3. Net Mode
Display the weight added since the preset has been entered. As ingredients are loaded, the
weight display counts upward, as they are unloaded the weight display counts down.
Switching between these display modes is possible at any time.
Before the preset weight is reached, the pre-alarm is activated. This causes the preset display
annunciator, the front panel alarm light, the output relay, and the alarm horn all to pulse in
sequence with the alarm light. A pre-alarm provides an early warning before reaching the preset.
Set the pre-alarm value to 0 (zero) to prevent the alarm output from pulsing. See page 15: To
change the pre-alarm value .
Once the preset weight amount has been added or removed, the scale will activate an alarm. The
front panel alarm light, the output relay, the preset display annunciator, and the alarm horn will
all be held ON. See page 13:
To clear the preset alarm .
4
4
preset
1 1
2
5
2x
293
% !