DH Satellite 39 Polar Or Az-EL Series - Manual (Page 5)

ASSEMBLY OF THE ANTENNA
(On Ground: Lift As One Piece)
FIG. #9
FIG. #10
IMPORTANT!!
If you have purchased a 4 piece sectional
antenna follow these instructions.
The antenna will come in 4 pieces each having a color coded dot on the rib (see FIG. #9). NOTE: After
complete installation you will no longer see the colored dots. You must take two sections of the antenna
and place them on a flat surface face down allowing for an installer to work on attaching the numbered ribs.
The antenna must always stay in crate until assembled. (see FIG. #10). Take panel one labeled 08/1 and 08/2
and attach it to panel 2 which is labeled 08/2 on one rib and 08/3 on the other rib. Connect panel 1 with rib
#2 (labeled 08/2) to panel 2 with rib #2 (labeled 08/2), matching the #2 on each rib of the two panels (See
photos below). Install 1/4" x 3/4" bolts in all holes, finger tight. Continue on to the next panel in the same
manner until finished with all panels. Now tighten all hardware.
Match 2 with 2
The top number represents the serial number of the antenna. *Example: In FIG. #9 you will see 4
sections with the top number 08. You will take all four pieces of 08 to make one complete antenna.
Rib number. *Example: On a 4 piece 3.0m antenna the dot will have a 08 on the upper part of
the dot (serial number) and the lower number of 1, 2, 3, 4 are the rib numbers.
Rib
Return to page 4 (FINAL ASSEMBLY OF ANTENNA AND MOUNT)
Page 5