DH Satellite 60 Horizon to Horizon/Powered Dec - Manual (Page 22)

Power Declination Option
Look carefully at the drawing on page 14. This shows where the declination actuator is place on the
mount. This mount must be ordered from the factory with this option as it is not a retrofit kit. The end of the
actuator attaches between the two tabs that are welded to the square tube attached to the ring using a 3/4” x
2 1/2" bolt, flatwashers, lockwasher and nut. The actuator clamp is attached to the actuator as per the
manufacturer’s recommendation. This clamp is then attached to the power declination bracket connected to
the boom end of the mount using a 1/2" x 3 1/2" bolt, lockwasher and nut.
Page 15