DH Satellite 60 Horizon to Horizon/Powered Dec User Manual
Page 19
4. Once you obtain the best signal strength, drive the dish over with a drill to the last few satellite signals
that you had done previously. Note if the signal strength has improved from the adjustments that were
just made.
5. Peak the satellite signal out on the farthest satellite you are trying to obtain(we used 131W). Note the
signal and then adjust the turnbuckle again either up or down seeing if this increases or decreases the
signal strength. If it does, you will need to repeat the steps under Adjusting arc until you are satisfied
with the signal strengths with the satellite signals you are trying to obtain.