DFI BT100 - Manual (Page 35)

www.dfi .com
35
Chapter 3 BIOS Setup
Chapter 3
Super IO Configuration
This section is used to configure the parameters of the super IO chip.
WatchDog Timer Unit
Selection.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Super IO Confi guration
Super IO Chip
WatchDog Timer Unit
Super IO WatchDog Timer
 Serial Port 1 Confi guration
 Serial Port 2 Confi guration
 Serial Port 3 Confi guration
 Serial Port 4 Confi guration
 Serial Port 5 Confi guration
 Serial Port 6 Confi guration
Advanced
NCT6106D
[Second]
0
WatchDog Timer Unit
Selects the WatchDog Timer Unit: second or minute.
Super IO WatchDog Timer
Enter the value to set the Super IO WatchDog timer. 0 means disabled.
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Reset
ESC: Exit
Enable or Disable Serial
Port (COM)
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Serial Port 1 Confi guration
Serial Port
Device Settings
Change Settings
Advanced
[Enabled]
IO=3F8h; IRQ=4;
[Auto]
Serial Port 1 Configuration to Serial Port 6 Configuration
Sets the parameters of serial port 1 (COM A) and serial port 6 (COM F).
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable or Disable Serial
Port (COM)
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Serial Port 2 Confi guration
Serial Port
Device Settings
Change Settings
Advanced
[Enabled]
IO=2F8h; IRQ=3;
[Auto]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit