Jumper settings, Chapter 2 jumper settings – DFI BT100 User Manual
Page 12
www.dfi .com
12
Chapter 2 Hardware Installation
Chapter 2
Jumper Settings
PS/2 Keyboard/Mouse Power Select
JP10
JP10 is used to select the power of the PS/2 keyboard/mouse port. Selecting +5V_standby
will allow you to use the PS/2 keyboard or PS/2 mouse to wake up the system.
2-3 On:
+5V_standby
1-2 On: +5V
(default)
1
3
2
1
3
2
Important:
The +5VSB power source of your power supply must support ≥720mA.
Mounting
holes
4. Place the heat sink assembly on top of the CPU. The 4 screws around the heat sink must
match the screw holes of the retention module base. We strongly recommend using this
type of heat sink assembly because it provides adequate cooling to the components of the
system board.
Turn each Phillips head screw half way down first to initially stabilize the heat sink onto
the board, then finally tighten each screw.
Important:
Do not turn the first screw all the way down followed by the next and so on. This is
to avoid imbalance which might cause cracks or fractures to the CPU and/or heat sink
assembly.
Mounting
screws