DFI BT100 - Manual (Page 23)

www.dfi .com
23
Chapter 2 Hardware Installation
Chapter 2
RJ45 LAN Ports
Features
• 2 Intel ® I210AT PCI Express Gigabit Ethernet controllers
The LAN ports allow the system board to connect to a local area network by means of a net-
work hub.
BIOS Setting
Configure the onboard LAN in the Chipset menu (“South Bridge Configuration” submenu) of
the BIOS. Refer to chapter 3 for more information.
Driver Installation
Install the LAN drivers. Refer to chapter 4 for more information.
LAN 1
LAN 2
LAN 1
LAN 2
USB Ports
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The system board is equipped with one onboard USB 3.0 port (USB 2) and three onboard
USB 2.0 ports (USB 0, USB 1 and USB 3). The 10-pin connector allows you to connect 2 ad-
ditional USB 2.0 ports (USB 6-7). The USB port 5 is the mini USB device for the external hard
drive. The additional USB ports may be mounted on a card-edge bracket. Install the card-edge
bracket to an available slot at the rear of the system chassis and then insert the USB port
cables to a connector.
BIOS Setting
Configure the onboard USB in the Advanced menu (“USB Configuration” submenu) of the
BIOS. Refer to chapter 3 for more information.
Driver Installation
You may need to install the proper drivers in your operating system to use the USB device.
Refer to your operating system’s manual or documentation for more information.
10
VCC -Data
+Data
GND Ke
y
VCC -Data +Data GND N.C.
9 1
2
USB 2
USB 2.0
USB 2.0
USB 3.0
USB 6-7
USB 3
USB 0
USB 1
USB 2.0
USB 5
1
+5V_standby
-Data +Data GND
USB 2.0