DFI BT100 - Manual (Page 18)

www.dfi .com
18
Chapter 2 Hardware Installation
Chapter 2
Digital I/O Power Select
1-2 On: +5V
(default)
2-3 On: +5V_standby
JP23 is used to select the power of Digital I/O signal.
Digital I/O Output State
1-2 On: +5V or
+5V_standby
(default)
2-3 On: GND
Based on the power level of DIO (Digital I/O) selected on JP23, JP25 (DIO pin 3/5/7/9) and
JP24 (DIO pin 11/13/15/17) are used to select the output state of Digital I/O: pull high or pull
low. When selecting pull high, the power selection will be the same as JP23’s setting.
JP23
1 3 2
1 3 2
DIO 11/13/15/17
(JP24)
1 3 2
1 3 2
DIO 3/5/7/9
(JP25)