Devolo MicroLink ADSL Modem Router - Manual (Page 8)

Connection and installation
|
| devolo MicroLink ADSL Modem Router |
8
EN
2 Connection and installation
This chapter explains the display and connections of the MicroLink ADSL
Modem Router and shows you how to set up the device and connect compu-
ters as well as other network devices. Two network examples are illustrated
at the end of the chapter.
2.1 Display and connections
Power Power supply.
Link WAN connection; lit when a connection exists to the Internet
access device. Flashes during training.
Connect Lit when an active point-to-point connection exists.
Data Lit during data transfers.
Ports 1 ... 4 Connections for up to four computers or switches (hubs) in
LAN.
Link/Act Link = connection, Act = activity. Lit when a computer (or hub/
switch) is connected. Flashes during data transfers.
FD/Col FD = Full Duplex, Col = Collisions. Lit during full duplex opera-
tion. Flashes during data collisions.
10/100 10/100 = 10 or 100 Mbps. Lit when data transfer rate is 100
Mbps.
Button for manual reset. If this button is pressed for longer
than one second, all of the stored configuration data will be
deleted and the router will be restored to its factory defaults.