Devolo MicroLink ADSL Modem Router - Manual (Page 29)

|
Router configuration 29
| devolo MicroLink ADSL Modem Router |
EN
Next, click Upload to load the firmware or Cancel to interrupt the process.
The router will restart automatically when the firmware update is complete.
The router switches into a special mode during firmware uploads; the ADSL
module is disabled in this mode, for example. Configuration functions and
Internet access are also disabled during this process. The router will remain
in this mode—even if the power is switched off—until the new firmware has
been successfully loaded or the update process canceled.
When the firmware update is complete, it is necessary to reset the router to
its factory defaults by pressing the button on the rear panel of the device.
When the router restarts, the 'Connect' LED will be lit for around 1 minute. Do
not interrupt this process! Switching the MicroLink ADSL Modem Router
off during this time can irreparably damage the router's firmware.