Devolo dLAN TV SAT Starter Set - Manual (Page 26)

Initial use 25
devolo dLAN TV SAT Starter Set
3.8 Connecting the
dLAN TV SAT to IP Receiver to
the dLAN and the mains supply
ቢ Connect the dLAN TV SAT to IP Receiver to a
dLAN adapter using the included network cable.
The Ethernet plug (LAN) should only be
connected to a matching Ethernet sock-
et.
ባ Insert the hollow plug on the power pack into the
12 V DC power socket on the
dLAN TV SAT to IP Receiver.
ቤ Insert the plug of the mains adapter into the
socket on the dLAN adapter.
ብ Then plug the dLAN adapter into a free wall
socket.
ቦ The dLAN TV SAT to IP Receiver is now connected
to the mains supply and dLAN network and can
communicate with the dLAN TV SAT Multituner,
which is connected via dLAN (see also 3.6.2
Connecting the dLAN TV SAT Multituner). To
secure your dLAN network, continue with your
network configuration. For more information,
refer to the chapter 7 dLAN network.
Note that to use HbbTV and DLNA (me-
dia server), you will need another
dLAN adapter for each to connect them
to the dLAN network.
(see 2.5 Sample applications)
To avoid electrical damage when con-
necting the
dLAN TV SAT to IP Receiver, always use
the power pack supplied. This is de-
signed to supply electrical devices with
12 V DC. Make sure there is a separate
power supply when connecting several
devices.
3.8.1 First use
ቢ After successfully connecting all components of
the dLAN TV SAT Starter Set, switch on the
dLAN TV SAT to IP Receiver.
ባ Then switch on the TV set.
If you have connected the devices by HDMI,
select the corresponding output to display
the TV image.
ቤ Press the button for the signal input on the TV set
(usually at the side) or on the remote control. The