Devolo dLAN TV SAT Starter Set - Manual (Page 18)

Initial use 17
devolo dLAN TV SAT Starter Set
3.3 Indicators and connections of
the dLAN TV SAT Multituner
On the back of the housing next to the two antenna
connections you will find the dLAN LEDs, the encryp-
tion button and a network jack.
The power jack is located on the side of the housing.
Antenna connections
This is where you connect the satellite system to the
dLAN TV SAT Multituner using the coaxial cable. Once
you have made the two connections, you can, for ex-
ample, simultaneously watch television and record an-
other programme; one satellite connection is used for
the television and the other for the recording.
Control lamps
The control lamps (LEDs) show the status for each of
the dLAN connections by illuminating and/or flashing
in different ways.
b Power: Lit a steady green if the
dLAN TV SAT Multituner is ready to operate;
flashes green if the dLAN TV SAT Multituner is in
standby mode. A few seconds after the device is
switched on, it goes into PowerSave mode by
default.
Fig. 5