beautypg.com

Security, Operation summary, Programming – Dataprobe PowerPal Single User Manual

Page 5

background image

POWER PAL

Page 5

SECURITY

Additional security can be added to Pal’s power control and extension ringing features. With security enabled, a
security code is required before gaining access to the power control. Once the security code is received, Pal will
respond with the status. (ON = 2 Beeps OFF = 1 Beep). The security code can be from one to six digits long.

The security feature can be set for just power control, or both the power control and extension ringing functions.

When set for Power Only; all callers have unrestricted access to the extension, while a code is required for power
control. When set for Both Power and Extension; security code is required for all Pal functions.

If an incorrect security code is entered, Pal will send a low Error tone and wait for a second attempt. If the second
attempt is incorrect or if no security code is entered at all, Pal will check the security level. With security level 0
and 1 Pal will ring the Extension Port. With security level 2 the call is disconnected.

OPERATION SUMMARY

Command

Code

Remarks

Status Command

1

Pal responds with power status
1 Beep = Off, 2 Beeps = On
Power does not change.

Power Toggle
Command

#

Power Changes and new status is
reported

Pulse Power

*

Power is pulsed for preset time.
(Programmable from 5 to 45
seconds).

Ring Extension

0

Rings through to extension and
discontinues power control

PROGRAMMING

Warning:

Disconnect all equipment from PowerPal’s A/C receptacle when programming Pal.

All user programmable settings are set using a touch tone telephone connected to Pal’s Extension Port (EXT).
Settings are stored in non-volatile memory and will not be lost when power is removed from Pal.

To enter the Programming Mode: disconnect the telephone dial line connected to Pal, pick up the phone handset

(go off-hook) and enter

Pal responds with two Beeps to confirm programming mode.

Programming Pal

Each setting for Pal has a number code. Once in the programming mode, each feature is set by entering the

feature number, then the setting for that feature, followed by a

to confirm entry and set the new value.

Feature Number

à

à New Value à

à

This can be repeated as many times as necessary. It is not necessary to program the features in order. If an
incorrect entry is made, Pal will send the low Error tone. Reenter the number, value and star to continue.

To end the programming mode, hang up the phone and reconnect the dial line to Pal.