beautypg.com

Figure 35: driver board -5, Figure 36: driver to module configuration -5 – Daktronics AF-3080-68-R,A User Manual

Page 47

background image

4. Reverse the above procedure to

install a new display board.

Figure 35: Driver Board

The driver is a circuit board responsible for
switching the intensity levels of the LEDs. It
is located inside the driver box and mounts
on the back of the module. To remove a
driver board:

1. Open the display as described in

Section 4.5.

2. Disconnect all power and signal

connections from the driver board.

3. Remove the four #6 nuts holding the

board in place.

4. Gently lift the board from the display.
5. Reverse the above procedure to install a new driver board.

The following connectors are found on each driver board; refer above for Figure 35.

LED/Connector

Function

J4

Signal out to next driver
board

J3 Signal

in

J1-J2, J6-J7

Output to display boards

J5 Power

DS1 Power

indicator

Figure 36: Driver to Module Configuration

Maintenance and Troubleshooting

4-5