Daktronics AF-3080-68-R,A - Manual (Page 36)

Figure 29: Fiber Signal Converter to Fiber Board in Display
Signal Converter Field Cabling Sign A Data In
J2 (TX1) J5 (RX2)
J3 (RX1) J4 (TX2)
Venus
®
1500 Radio Client
Reference Drawing:
Schematic, Internal, WO/Quick Connect ..................... Drawing B-185325
A display that is controlled using a radio requires a Server radio connected to the
control computer, and a Client radio at the display. The radios must be within line-
of-site of each other.
The diagram below shows the connections to the Server radio through a Signal
Converter. The Client radio must be located within 25 feet of the display, therefore
25 feet of cable is supplied with the Client radio. One end of the cable is pre-
terminated to TB1 inside the radio enclosure, and the other end will need to be
terminated to TB1 on the controller board in the display. Refer to Drawing
B-177662 and the Radio manual (ED-13348) for the correct cable terminations.
Electrical Installation 3-12