Daktronics AF-3112-34-R,A - Manual (Page 8)

Figure 1 below illustrates the Daktronics drawing label. The drawing number is
located in the lower-right corner of the drawing. Listing the last set of digits and the
letter preceding them identifies drawings in the manual. In the example below, the
drawing would be referred to as Drawing B-181287. Reference drawings are
inserted in Appendix A.
Figure 1: Drawing Label
All references to drawing numbers, appendices, figures, or other manuals are
presented in bold typeface, as shown below.
“Refer to Drawing B-181287 in Appendix A for the power supply location.”
Additionally, drawings referenced in a particular section are listed at the beginning
of that section as seen in the following example:
Reference Drawing:
Shop Drawing; VF-****-27x75-18-W............................ Drawing B-181287
Daktronics displays are built for long life and require little maintenance. However,
from time to time, certain display components will need replacing. The
Replacement Parts List in Section 4.11 provides the names and numbers of
components that may need to be ordered during the life of the display. Most display
components have a white label that lists the part number. The component part
number is in the following format: 0P-_ _ _ _-_ _ _ _ (component) or
0A-_ _ _ _-_ _ _ _ multi-component assembly).
Following the Replacement Parts List is the Daktronics Exchange and Repair
and Return Programs in Section 4.12. Refer to these instructions if any display
component needs replacement or repair.
1.2 Safety Precautions
Important Safeguards:
1. Read and understand these instructions before installing.
2. Be sure the display and other exterior enclosures are properly grounded
with an earth ground electrode at the display.
3. Disconnect power when servicing the display.
4. Do
not modify the display structure or attach any panels or coverings to the
display without the written consent of Daktronics, Inc.
Introduction 1-2