Daktronics AF-3112-34-R,A - Manual (Page 34)

1. Mount the enclosure within 30 feet of the display.
2. Route fiber optic cable to the enclosure. Two fibers are required.
3. Connect the fiber at the signal converter and to the fiberboard in the
enclosure. Connect transmit to receive and receive to transmit. Refer to
Figure 28 for fiber termination locations.
4. Connect the quick connect cable from the enclosure to J33 on the back of
the primary display.
Figure 28: Signal Converter to Fiber Card Enclosure
Signal Converter to Fiber Board
Signal
Converter
Field Cabling
Fiber Control
Card
J2 Transmit (TX1) (Color Varies) J5 Receive (RX2)
J3 Receive (RX1) (Color Varies) J4 Transmit (TX2)
Venus 1500 Radio
Reference Drawings:
System Riser Diagram, QC Outdoor Radio, Gen 2..... Drawing A-185359
A radio-controlled display requires a Server radio connected to the control computer
and a Client radio at the display. The radios must be in line-of-site of each other. The
Client radio is provided with 25 feet of weather resistant pre-terminated cable. Refer
to Drawing A-185359 and
Figure 29 for the system layout.
Electrical Installation 3-14