Daktronics DF-1050/1051/1052/1053 - Manual (Page 39)

Parking Garage Display Operation 5-3
The controller will then list the “Current Function” if it is Parking you can continue,
otherwise at the next frame:
Current Function?
Press Set Funct
At this frame you need to press <
CLEAR/SET FUNCTION > and use the < ↑↓ > to select
Parking.
Note: Press the < CLEAR/SET FUNCTION > key quickly to enter the function mode. If
you miss this step, unplug the power to the DataMaster controller and start again.
Use the following table as a guide to startup procedures.
LCD Screen Action
CURRENT FUNCTION
PARKING
Plug the wall pack transformer into a 120 V
AC power outlet, and connect it to the
DataMaster 100.
This display appears briefly.
CHANGE FUNCTION?
PRESS SET FUNCT
This message appears next on the screen.
If “PARKING” was shown on the bottom
line of the LCD during startup, do nothing.
The controller will automatically default to
previous Parking Garage display settings.
If a function other than “PARKING” was
shown on the bottom line of the LCD
during startup, press the <
SET FUNCTION >
key while the second LCD prompt is
displayed.
SELECT FUNCTION
PARKING
↓↑
Press the up or down arrow keys <
↑↓ >
until the Parking Garage display option is
shown. Press the <
ENTER > key to accept.
The handheld controller should now be ready for use. The controller will
“remember” the last function setting, so this step should only need to be done with a
new controller, or one that is configured for different displays.
Note: The actual Parking values will not be displayed on the DataMaster 100 LCD
screen because these values are kept in the display itself.