Daktronics BA-2515-31 DistaView Outdoor LED Scoreboard - Manual (Page 25)

IMPORTANT NOTES :
1. Disconnect power before doing any repair or maintenance work on the scoreboard!
2. Permit only qualified service personnel to access internal display electronics.
3. Disconnect power when not using the scoreboard.
For front-access scoreboards, all internal
electronic components and digits are
reached by opening an access door or a
digit panel on the front of the display.
Digit panels are held in place on the
scoreboard face by an offset flange across
the top and by screws at the bottom, as
shown in Figure 20.
To open an access panel:
1. Hold the digit panel in place by
putting hand pressure on it and
remove the screws.
2. Carefully lift the panel away from
the scoreboard, sliding it out and
down.
Refer to the following drawings to locate drivers, power, and signal components.
Reference Drawings:
Component Locations; BA-2515-31, G3LC ............................................ Drawing A-222583
Component Locations; BA-2715-31, G3LC ............................................ Drawing A-230119
Component Locations; BA-2718-31, G3LC ............................................ Drawing A-206050
Component Locations; BA-2618-31, G3LC ............................................ Drawing A-208073
Component Locations; SO-2918-31, G3LC ........................................... Drawing A-220840
Component Locations; MS-3918-31, G3LC ........................................... Drawing A-220350
Component Locations; FB-4005-31, G3LC ............................................ Drawing A-221249
Figure 20: LED Digit Panel
Note:
If the panel is not held in place when the screws are removed, it could drop
immediately, possibly damaging LEDs or the digit harness.