Desa FDCFRN - Manual (Page 24)

www.desatech.com 111244-01C 24
OPERATING FIREPLACE
Continued
5. Press in and turn control knob counter-
clockwise
to the PILOT position.
Press in control knob for five (5) seconds
(see Figure 39).
Note: You may be running this fireplace
for the first time after hooking up to gas
supply. If so, the control knob may need to
be pressed in for 30 seconds or more. This
will allow air to bleed from the gas system.
6. With control knob pressed in, press and re-
lease ignitor button. This will light pilot.
The pilot is attached to the front burner. If
needed, keep pressing ignitor button until
pilot lights.
Note: If pilot does not stay lit, contact a
qualified service person or gas supplier for
repairs. Until repairs are made, light pilot
with match. To light pilot with match, see
Manual Lighting Procedure.
7. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
• If control knob does not pop out when re-
leased, contact a qualified service person
or gas supplier for repairs.
Note: If pilot goes out, repeat steps 4
through 8.
8. Slightly push in and turn control knob coun-
terclockwise
to the ON position.
9. Set flame adjustment knob to any level be-
tween HI and LO.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
Figure 39 - Control Knob and Ignitor
Button Location (Shown as Supplied -
No Control Options)
HI
LO
IN OUT
Piezo
Ignitor
Button
Control
Knob Flame
Adjustment
Knob
Figure 40 - Propane/LP Gas Pilot
Ignitor
Electrode
Pilot
Burner
Figure 41 - Natural Gas Pilot
Ignitor
Electrode
Pilot Burner
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Fireplace
1. Turn control knob clockwise to the
OFF position.
2. If Using Optional Hand-Held Remote: Set
selector switch in the OFF position to pre-
vent draining battery.
Shutting Off Burners Only (pilot stays lit)
You may shut off the burners and keep the pi-
lot lit by doing one of the following:
1. Turn control knob clockwise to
the PILOT position.
2. If Using Optional Hand-Held Remote: Use
remote control manual OFF button.
WARNING: Make sure re-
mote sensor selector switch is
in the OFF position when you
are away from home for long
periods of time.
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 5 under Lighting In-
structions, starting on page 23.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob. Now follow steps 8 and
9 under Lighting Instructions.