beautypg.com

Operating fireplace – Desa FDCFRN User Manual

Page 23

background image

www.desatech.com

111244-01C

23

OPERATING FIREPLACE

Continued

OPERATING

BLOWER

This blower has three settings: ON, OFF, and
AUTO. In the ON position, the blower will op-
erate constantly. In the OFF position, the
blower will not operate. In the AUTO position,
the blower will start when the thermostat senses
a sufficient increase in firebox temperature.

Note:

Your fireplace and thermostat blower

will not turn on and off at the same time. The
fireplace may run for several minutes before
the blower turns on. After the heater modulates
to the pilot position, the blower will continue to
run. The blower will shut off after the firebox
temperature decreases.

Note:

It is safe to operate fireplace with blower

turned off. However, the blower helps distrib-
ute heated air from the fireplace.

Figure 38 - AUTO/OFF/ON Blower Switch

AUTO/OFF/ON Switch

REMOTE-READY MODELS

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.

A. This appliance has a pilot which must be

lighted by hand. When lighting the pilot,
follow these instructions exactly.

B. BEFORE LIGHTING smell all around the

appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.
• Do not touch any electric switch; do not

use any phone in your building.

LIGHTING

INSTRUCTIONS

WARNING: You must oper-

ate this fireplace with the screen
in place. Make sure fireplace
screen is installed before run-
ning fireplace.

NOTICE: During initial operation
of new fireplace, burning logs
will give off a paper-burning
smell. Open window to vent
smell. Operate fireplace on HI
position to burn off odor. This
will only last a few hours.

WARNING: Burner will come

on automatically within one
minute when control valve is in
the ON position after the pilot is lit.

1.

STOP! Read the safety information start-
ing in column 1.

2.

Make sure equipment shutoff valve is fully
open.

3.

Press in and turn control knob clockwise

Clockwise

to the OFF position (see Figure 39,

page 24).

4.

Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor.
If you smell gas, STOP! Follow “B” in the
safety information, column 1. If you don’t
smell gas, go to the next step.

• Immediately call your gas supplier from

a neighbor’s phone. Follow the gas
supplier’s instructions.

• If you cannot reach your gas supplier, call

the fire department.

C. Use only your hand to push in or turn the

gas control knob. Never use tools. If the
knob will not push in or turn by hand, don’t
try to repair it, call a qualified service tech-
nician or gas supplier. Force or attempted
repair may result in a fire or explosion.

D. Do not use this appliance if any part has been

under water. Immediately call a qualified ser-
vice technician to inspect the appliance and
to replace any part of the control system and
any gas control which has been under water.

This manual is related to the following products: