CREATOR WiFi Conference System - Manual (Page 21)

CREATOR CHINA 2013-09 WWW.CREATOR1997.COM
15 WiFi Conference System User‘s Manual
interference or not, select "Auto".
Channel:
Channel selection, you should select the channel
with no or little interference in current network,
otherwise it is easy to cause interference to the
WIFI conference system.
Channel Width:
Occupied channel width, which directly affect the
network maximum transmission rate. Select
"20MHz", the maximum transmission rate is
150Mbps, select "40MHz", the maximum
transmission rate is 300Mbps, you are
recommended to choose "Auto 20/40 MHz".
Authentication:
Authentication: password authentication type. In
order to ensure data security, WIFI conference
system’s fixed password authentication type is
"WPA-personal".
WPA Mode:
WPA is a WLAN security enhancement solution
which is based on standard. It is interoperable,
can greatly enhance the data protection and
access control level of existing and future
wireless LAN systems. In order to improve the
security levels of data, WIFI conference system
fixed the option as "WPA2 Only".
Cipher Type:Password type is fixed "AES"”
Group Key Update Interval:
AES/TKIP password update interval. The fixed
password is "AES" in the former setting, this
setting does not work, just keep the default value.
Choose password update to "Manual", custom.
Pass Phrase:
Wireless password, the password required for the
unit terminal to change AP through wireless
connection. It should be fixed to "9999999999",
10 "9"s.
Confirm Pass Phrase:
Confirm the password. Input the former
password again.
So far Wireless Settings are completed. As
shown below:
Figure 4-5
Click on the button to save the
setting.
◆
LAN:
Network setting: set the IP address in the setting
options of this column.
LAN Settings:
Select the fixed IP address (the default), if you
want to assign a static IP address or a fixed
address, you have to complete the following
matters.
Select "Static IP (manual)" option in "Get IP
From" menu, set as follows:
Local IP Address:The local IP address, in the
same network the IP address must be the one
and only, the system default IP address is
196.168.2.1.
Subnet Mask:
Subnet mask, the subnet masks in the same
network must be identical, the system default is
255.255.255.0.
Default Gateway: can leave blank, without
setting.
As shown below::