Contemporary Control Systems BASremote Installation Guide - Manual (Page 18)

TD040300-0II
18
Analog Output
Either voltage in the range of 0–10 VDC or current in the range of 0–20
mA can be outputted by assigning analog outputs. Configure an output
using a web page. Select the appropriate range. For DC voltage, the
output voltage is applied to point A with respect to common. For DC
current, the output current is sourced from point A to common so there
is no need for a loop supply. A current output can source up to 20 mA
into a resistive load not exceeding 750 Ω. Verify the burden that a
current output device will present. The BAS Remote can not generate
enough voltage to drive loads with higher resistance.
Figure 15 — Analog Output Connections
Figure 15 illustrates connections to a three-wire damper actuator. The
damper requires a 0–10 V command signal which can easily be
accomplished by the BAS Remote. However, if a current output is
desired it is possible to set the BAS Remote analog output to 4–20 mA
and install an external 500 Ω resistor that will convert the 4–20 mA
signal to 2–10 V.