Comtech EF Data CMR-5975 Manual - Manual (Page 82)

Digicast Media Router S2 Receiver CMR-5975 (MR-S2) Revision 3
Device Management via User Interfaces MN-CMR5975-IOM
4-54
4.4 Telnet Interface
Telnet provides a textual interface over a LAN. Most PCs have the capability to use Telnet. To
use Telnet on a Microsoft Windows
®
product, click , then .
The Run dialog box is shown in Figure 4-45. In the Open: text window, enter “telnet
xxx.xxx.xxx.xxx,” where xxx.xxx.xxx.xxx is the IP address of the MR-S2. If the port number
has been modified from the
standard 23 via the Terminal Interface, then the port number must be
appended with a colon to the IP address.
Figure 4-45. Starting Telnet Session
The user will be prompted to enter the user name and password to gain access to the telnet
interface.
Once the menu is started, press and the MR-S2 Main Menu will display as shown in
4-46. Main Menu . The user may navigate the menus in the same manner as the Terminal
Interface. With specific exceptions as noted in the Terminal Interface section, the menus available
via Telnet and Serial interfaces are identical.
NOTE
The default username is “comtech” and the default password is
“comtech”, both of which are case sensitive.