Comtech EF Data CMR-5975 Manual - Manual (Page 59)

Digicast Media Router S2 Receiver CMR-5975 (MR-S2) Revision 3
Device Management via User Interfaces MN-CMR5975-IOM
4-31
4.3.4.1 Vload Configuration Menu
Figure 4-23. Vload Menu
Vload is a system used to remotely update the MRS-2 receiver via multicast transmission. Please
refer to the Digicast section of the Vload manual for information on how to use the head-end
software component of Vload.
IP Address
The multicast address to be used for Vload. Please note that the multicast address used here
should not be used in any other route settings.
PID
Define the PID value (in hexadecimal format) to use for Vload.
Note: This PID value cannot be used or defined elsewhere on this receiver.