Comtech EF Data CMR-5975 Manual - Manual (Page 35)

Digicast Media Router S2 Receiver CMR-5975 (MR-S2) Revision 3
Device Management via User Interfaces MN-CMR5975-IOM
4-7
4.2.3 Vload Configuration
Vload is a system used to remotely update the MRS-2 receiver via multicast transmission. Please
refer to the Digicast section of the Vload manual for information on how to use the head-end
software component of Vload.
Figure 4-6. Vload Configuration Page
IP Address
The multicast address to be used for Vload.
Please note that the multicast addressed used here should not be used in any other route
settings.
PID
Define the PID value (in hexadecimal format) to use for Vload.
Note: This PID value cannot be used or defined elsewhere on this receiver for carrying user data
traffic.