Comtech EF Data XPLINK - Manual (Page 23)

XSAT Palm Link 2 Revision 0 MN/XPLINK.IOM
21
15.7 C HANGE THE B ATTERIES
The organizer loses data after one minute, so the battery replacement operation must be
completed quickly.
1. Have new batteries on hand.
2. Open the package and place the batteries near the organizer.
3. Find the organizer’s batter door, located immediately above the serial connection on the back
of the unit.
4. Working quickly, remove the organizer battery door:
a Place slight downward pressure on the "fingernail"-like depression.
b. Slide the door out towards the side.
5. Take one battery out of the organizer, note its orientation, and place it away from the new
batteries.
6. Place a new battery where the old one was, with the same orientation (the battery compartment
also shows proper orientation with "+" and "-" symbols).
7. Repeat steps 4 through 7 for the other battery (note that the orientation is different).
8. Slide the battery door back in place.
15.8 I F THE O RGANIZER W ON ' T T URN O N B ECAUSE T HE B ATTERIES A RE
D
EAD
If the organizer does not turn on when the power button is pressed, replace the batteries
immediately.
If the batteries are depleted so that the organizer does not operate, there should be enough residual
power left to store data safely for a few weeks.
However, if you leave depleted batteries in the organizer for an extended period of time, all of the
stored data can be lost. If this happens, replace the batteries and use the reset button to reset the
organizer. It is necessary to re-load the CPXLINK software after resetting the organizer. To obtain
a copy of the CPXLINK software, please contact Comtech EF Data Customer Service.