Comtech EF Data M&C Software - Manual (Page 22)

M&C Software Revision 3
Operation MN/M_C17.IOM
2–8 MN/M_C17.IOM
2.3.1 Programming a Pre-Select
To program a pre-select with the current frequency and attenuation settings:
1. Press
[
↑
] or [
↓
] to select the desired pre-select.
2. Perform one of the following steps:
a. Type PROG and press [ENTER].
b. Press the space bar to toggle to PROG, and press [ENTER].
The current frequency and attenuation settings will be displayed in the
appropriate locations on the screen.
2.3.2 Clearing a Pre-Select
To clear a pre-select:
1. Press
[
↑
] or [
↓
] to select the desired pre-select.
2. Perform one of the following steps:
a. Type CLR and press [ENTER].
b. Press the space bar to toggle to CLR, and press [ENTER].
The frequency and attenuation for the selected pre-select will be removed.