Route table, 4 route table – Comtech EF Data CDM-IP Quick-Start Guide User Manual
Page 18
CDM-IP Quick Start Guide
Rev. 0
Getting Started
CD/CDMIPQSG.IOM
16
1.3.4 R
OUTE
T
ABLE
Perform the following steps on CDM-IP 1
Step Description
1
From Main Menu, select Route Table [R]sub-menu.
2
Enter 1 to configure the first route
3
Enter a suitable name
4
Set IP Address to 172.17.10.0
5
Set Number of Subnet Bits to 24
6
For Interface to which route is destined to
select S
6
For HDLC address [SMALL NETWORK] in hex <0x1 - 0xFE, enter = 0000>:
select 2
7
CDM-IP 1 Route Table should display the following:
Route Name Dest IP/SNet Bits Next Hop MultiCast State
Route001..[test 172.17.10.0/24 0x2 N/A toSat]
Perform the following steps on CDM-IP 2
Step Description
8
From Main Menu, select Route Table [R] sub-menu.
9
Enter 1 to configure the first route
10
Enter a suitable name
11
Set IP Address to 172.16.10.0
12
Set Number of Subnet Bits to 24
13
For Interface to which route is destined to
select S
14
For HDLC address [SMALL NETWORK] in hex <0x1 - 0xFE, enter = 0000>:
select 1
15
CDM-IP 2 Route Table should display the following:
Route Name Dest IP/SNet Bits Next Hop MultiCast State
Route001..[test 172.16.10.0/24 0x1 N/A toSat]